I have a QCOW2 image (Homeassistant VM), that I ran for several months without problems.

A few days ago, I reinstalled the VM host,so I copied the image to a backup drive and now wanted to start a VM from this image.

However, it always end up hanging at “booting from hard disk” and takes up 100% load on one core.

On the VM host, I imported the image like this:

# copied from HAOS wiki
sudo virt-install --name hass --description "Home Assistant OS" --os-variant=generic --ram=2048 --vcpus=2 --disk /var/vm/hass.qcow2,bus=sata --import --graphics none

To ensure that my host wasn’t broken, I tried the same image on another machine, that I know can run VMs (virtual machine manager, using the GUI), but same result. One core at 100% and no change at all.

I even let it run over night, but it was still at this point.

One machine runs NixOS, the other Debian 12.

What could cause this? There are no errors in journalctl or /var/log/qemu.

  • sailingbythelee@lemmy.world
    2·
    8 months ago

    I have also had VMs that hang on boot-up while running a core at 100%. I use Proxmox as my host, and was always able to enter the console for the VM and observe it going through the boot sequence. When it hung as you have described, it was because of some error that I could correct in the console. So, maybe check if your host allows you to interact with the VM while it’s booting.

    • AggressivelyPassive@feddit.deOP
      1·
      8 months ago

      I already tried that using virtual machine manager, I can see the “bios screen” and the blinking cursor after “booting from disk”, but that’s it.

      So there is nothing happening, at least vm manager doesn’t even register any RAM usage, just one core at 100%.

      • sailingbythelee@lemmy.world
        1·
        8 months ago

        That’s frustrating. I’m no expert, but since there are no other responses and I’ve had my fair share of problems to solve, maybe check:

        1. Is Secure Boot disabled in your BIOS?
        2. Does your image have the right permissions? Give it chmod 777 and see if it boots.
        3. I think you said you re-installed your host OS. Try installing an older version to see if it will boot your image.