Sovol SV08 350*350*345mm Core-XY 3D Printer With Camera
www.sovol3d.com
Shop best budget 3d printer with advanced features on Sovol official Store, founded in 2018. Ship in 24 hours, 2-4 days for delivery, 1 year warranty. 24/7 customer support

The SV08 is marketed as a mass-produced Voron 2.4, with a much lower price and a very quick setup. They even say they donate a small amount to the Voron project for each sale.

Has anyone here bought/tested it? What are your thoughts about it?

Are there some limitations/downsides compared to a Voron?

Is it possible to upgrade it Voron-style (Stealthburner, enclosure etc)?

  • WFH@lemm.eeOPEnglish
    3·
    5 months ago

    Than you so much for such a detailed analysis!

    For reference, I’ve had a (heavily modded) Creality Ender 3 V2 for a few years, and I’ve hit a limit in terms of speed and quality.

    The filament path between the extruder and hotend is poorly-constrained, making it a pain to load The auto-z calibration is often just a smidge off It uses a custom nozzle/heater

    If it’s possible to install a Stealthburner instead of the standard extruder/hotend combo, it might solve most of these issues. Maybe some people are working on a V6 or Mk8 style hotend (I have a metric fuckton of Mk8 nozzles laying around)…

    The fans are absurdly loud. All of them.

    OK Noctua upgrades then. Compared to an already absurdly loud Ender 3, is it worse?

    The mainboard is effectively a BTT CB1 and Fystec Cheetah on a single board Their software customizations are of dubious quality

    Would a Voron-style mainboard + RPi + standard Klipper solve these issues or are there fundamental incompatibilities?

    Thanks!

    • r6e@lemmy.worldEnglish
      2·
      4 months ago

      All of those upgrades are absolutely doable. Given the price of those upgrades, all-in, a Voron will be a better value. Unless you have most of the parts already, anyway.

      Although, I wouldn’t bother changing out the board unless you have specific needs. Firmware and config tweaks will take care of most issues I’ve seen with it.

      The fan is probably on par with stock ender 3. But always-on.