So I’m trying to get my printer to a point where i can pretty consistently turn out high quality prints, but I’m at a point now where i get results like this. These two prints are from the same batch, same print job, and I’m completely clueless on how to fix it. I have an ender 3 v2 with a bltouch, I’ve adjusted the eccentric nuts, tightened the belts until the tips of my thumb and index finger couldn’t tighten them any further, bed is level, using hatchbox pla. I know i can do ironing to fix the cosmetic problem, but I’d prefer to fix the root issue if possible.
Not sure how it works with your printer, but with mine on Klipper, after bed leveling I have to save and restart the firmware, and then I have to go back and select the profile that I just saved, otherwise it doesn’t use it.
That ain’t right 😹
Maybe try contacting klipper people https://github.com/Klipper3d/klipper/blob/master/docs/Contact.md
Or file an issue if you think it’s a bug.