Lately I’ve been using inland brand natural Pla. It prints so nice and I find that it adheres to the print bed really well. My go to filament brand used to be Amolen but some of these cheaper filaments have gotten so good in recent years.
Lately I’ve been using inland brand natural Pla. It prints so nice and I find that it adheres to the print bed really well. My go to filament brand used to be Amolen but some of these cheaper filaments have gotten so good in recent years.
I use three regularly: Polyterra PLA for low cost filaments, Polylite PLA Pro for my fastest prints or prints needing a little strength, and Polylite ASA for anything functional, for outdoors, or for high temp. The ASA surprised me with how easy it’s been to print. I’ve printed with 3DBestX ASA I think, and it’s OK, but not nearly as easy as the Polylite ASA. I bought a roll of ApolloX ASA recently but haven’t tried it yet.
If I need PETG, ESUN PETG prints the easiest, I’ve found. Not as easy as ASA (I have a heated chamber), but it’s the least aggravating PETG. ESUN PLA+ prints great, but is a bit more shiny than the Polylite PLA Pro, so it’s a personal preference. The ESUN PLA+ has slightly higher temperatures and I’ve had one print failure recently from poor layer adhesion when I was pushing it as hard as I could with print speed.
For my Monoprice mini select with a V6 hot end, I use whatever PLA is on sale. Right now Amazon Basics silk PLA, and two rolls of elegoo PLA. I rarely print high demand parts with the Monoprice. Right now it’s only printing 18650 holders for a cell balancer I’m building.