IMG_20231111_205431

I cant get my Anycubic Kobra 2 with Klipper to print correct. The first mm of each layer are faulty, resulting in a bad tooth in gears.

I tried to slow down the print, tried to minimize/deactivate retraction, fiddled with z offset and first layer height, lowered bed temp, altered the extrusion rate. Nothing works. Everything else seems fine, slim z seam, nice walls, no over/underextrusion.

Anyone got a hint how i could fix that?

Edit: I cancelled that Print, the Problem is only in the first tooth:

IMG_20231111_212736_745

the tooth in the marking should look like the ones above it.

  • Dkarma@lemmy.worldEnglish
    2·
    1 year ago

    This was my first guess. I’d also recommend an initial 1-2 loop skirt if it does this on the skirt it’s the level. If it still does it on the gear it’s the stl file.