Thank you all for your help! After yesterday’s Input I managed to Print my Box! The Problem was (mostly) the Bed temperature! The lower Bed temperature (60°C) and the now successful Firmware-Update (special thanks to DABDA) done the trick!

Thank you all for your help and your advice!

Hello I’m very new to 3D printing, I’m using a Sovol 06 with 1.75mm PLA. I’m trying to print a Box (for MTG-Cards). But everytime the bottom of the Box starts to “deatche” itself from the Bed. It starts with one corner and then progresses to the whole print. The Nozzle temperature is 200°C and the Bed temperature is 80°C. Can someone help?

  • DABDA@lemmy.worldEnglish
    5·
    11 months ago

    I have no personal experience with a failed firmware update but a quick search returned https://forum.sovol3d.com/t/sv06-bad-flash-probably-needs-bootloader/1452 and “solved” = https://forum.sovol3d.com/t/sv06-mainboard-brick-after-updating-sovol-firmware/862/52

    Seems like for some people it was ultimately the sd card being faulty that was causing the failure, especially if it was the sd card included with the printer.

    Good luck!

    • Roflmasterbigpimp@lemmy.worldOPEnglish
      5·
      11 months ago

      Thank you for your help! I’ve now set up a VM with Ubuntu and used a different FlashCard to safe it to. And now he is working again!

      • DABDA@lemmy.worldEnglish
        6·
        11 months ago

        Awesome, glad to hear it!

        When you’re ready to try printing again I agree with the suggestions to:

        • lower the bed temp to ~60c
        • avoid using glue sticks or similar since it shouldn’t be necessary with PLA, and will just add another variable
        • keep working through first layer print tests

        I’m surprised you’re having adhesion problems with a PEI build plate. When I swapped to PEI it was like magic; filament effortlessly sticks and finished prints pop off from a gentle flex. There isn’t like a plastic shipping cover on it or something is there?

        Anyway, good luck with the rest of your troubleshooting – I’m sure you’ll eventually get it dialed in :)