It heavily depends on the material if it will print fine at higher humidity, but having around 20-35 seems good afaik. I printed PLA successfully at around 55% for a long period before switching rooms and never had problems, but I wouldnt store PETG/TPU there without a sealed box

Whats wrong with the prusa? Considering getting one

Some found out that the camera feed isn’t e2e encrypted (eufy claimed they were) so you could see other people cameras

Dont know if it will work, but I think it’s worth a try. If it doesn’t work you can reset it or swap it back

You could also use unifi, not cheap but you can run everything local afaik.

You could also say its AWS. They also should have the experience, but mistakes happen

Its not that bad, its just all 5 seconds and not 2 seconds so no problem there! /s

I’m not only not buying a tesla because I’m not a fan of musk but also because I don’t have the money ;)