Ignotum

An NP-hard water problem?

Reistace is futile
carcinisation is inevitable
give up
give in
we are crab 🦀

God damn they beat me to it, and you beat me to tell them they beat me to it

Race conditions can make you a racist,
If you

1. Are behind the wheel of a racecar
2. You are on a racetrack

Then there’s no nice way to say it, you might be a racist, drive safe

“So this here is a rock”
“Uhh, in english please?”

Fiwefwox UwU

For the love of god OP don’t start your Linux journey with Arch
Don’t get me wrong, i use it and love it, but don’t use it!

I use arch btw

But what I am aware of is that when this person was triggered by a mere stranger expressing an opinion, they instantly went on the attack with namecalling, […]

But what he did here to a passing commenter speaks for itself.

Says the person that immediately accused the person of not being a victim but actually being the abuser, just because he is a man and was (understandibly) angry when someone said men don’t deserve as much help, since there are fewer male abuse victims

I would say that saying “go eat a bag of dicks” is not even close to as serious an accusing someone of being an domestic abuser, especially to someone who has been on the receiving end no less

Computers understand the content, but now how it’s represented, so they can’t solve it

Humans understand how it’s represented, but not the content, so they can’t solve it

Mathematicians understand how it’s represented and the content

It’s not to keep computers away, it’s to keep non-mathematicians away!

I’d rather bonk a thousand innocents than let one guilty go unbonked

• the indian police probably

You’re*

Get a minimum amount of compensation for doing a job? Do you hear yourself? That’s madness!

My best guess would be that you have some petg left in the nozzle that for whatever reason isn’t being melted and pushed out, what you could try is doing a cold pull

If you haven’t done it before, you basically heat up the hotend, feed in some plastic, then you turn off the heat and let it cool down until the plastic is partially hardened, then you yank on the filament

If everything goes right, the plastic down in the nozzle will be yanked out, and pull with it any impurities, leaving the nozzle clean and unclogged

Alternatively buy a new nozzle that you only use for PLA, i have heard a lot of people having issues like this when switching back and forth with the same nozzle

Ah maan, why’d you have to tell me that, it still feels like it came out just 3-4 years ago tops

Unsubscribe from marketing, a message reminding you of an upcoming service isn’t marketing? Nor is the message asking for feedback after a service?

Like always it will make it so 1% can relax and live even more comfortably, while 99% is left in the dirt

Keepass (open source password manager) can auto-fill not just username and password, but also generate and fill in one-time codes

Reduces the security the 2FA provides, but after i started using that it was pretty much zero extra effort to log in