If you have an m.2 slot, 2tb drives are cheap and don’t worry about it for a while
Edited: I originally absent mindedly said 2gb, meaning 2tb
If you have an m.2 slot, 2tb drives are cheap and don’t worry about it for a while
Edited: I originally absent mindedly said 2gb, meaning 2tb
It’s more likely than you think!™
If you ever do digitize it, or even going forward for other recipes you use, I recommend checking out the recipe app Paprika 3. I’ve been using it for years now and love it. It even bypasses pay walls on recipe sites like NYT cooking when downloading. Enter the url in the browser section, and hit download regardless of the paywalls I’ve encountered so far. I put cocktail recipes in there too.
This points to op not using default fedora partition schema but disk1 being the fedora install across those partitions
Or it could be swap, root, and home
I think this is what’s going on. I’m guessing the smallest partition is the boot partition, the 1gb might be the Linux swap, and the 100gb the Linux install.
We’ve done many of the same mods. Klipper, Skr, Sprite pro, crtouch. I did the dual z drive mod too, though I have no idea if that’s actually improved anything or not. Probably now that I’ve setup input shaping and have this thing whipping through prints.
Ok, yeah, forget the paper as far as regular leveling goes with the cr touch. Have you tried confirming your z offset since you changed the nozzle? If you haven’t, it should be fine every time you do something to the hotend.
Also make sure your heat block isn’t stripped out. I had a bitch of a time printing for a while only to discover I had overtightened my middle and stripped out the threads in the heat block. After I replaced it I had consistent good prints again.
Is there a way you can confirm your bed or nozzle temps? I know for the nozzle that’s a really difficult thing to do, it’s so small to be able to check with anything.
I ask because with your unexpected crash the other day from your post history, I wonder if your main board has glitched.
A 90c bed shouldn’t melt petg I’d think, so something is definitely weird there.
Might be worth trying to reflash your firmware in case the glitch isn’t hardware.
What other mods have you done to your printer besides spring spacers?
When you level the bed, is it manually and with a piece of paper to help gauge the distance?
These things have so many places something can go off that it’s really difficult to help troubleshoot without being there. Hopefully something in this post helps you out.
I can’t tell if the original post is an elaborate hoax with a link that never worked in the first place or if something is legit happening. Why would there be lines to vote already? Maybe I’m naive and early voting is that difficult in Georgia that people are lining up now. I don’t know, my ballot gets mailed to me by default and I can just walk up and drop it off any time up until polls close on election day. This feels like it’s a post to sow discord but 🤷♂️