Sumeron

Nice one, that’s a treasure trove of information!

So I’ve essentially started printing on a higher difficulty? Guess I’ll switch to PLA when the PETG runs out and change profiles in the slicer to PLA

Not for each new roll of filament, but I am relatively new (less than 1 month) and with the same roll I have some prints failing. Mostly because they detatch from the bed (Material is PETG, on an Ender 3 Max Neo). I’ve tried a lot of things already:

• Different nozzle temps
• Z axis offset calibration
• Cleaning the print-bed
• Leveling the print-bed (including the screws and the A4 paper trick)
• Heated bed vs. non-heated
• Printer placed in an enclosure to prevent drafts

So far it seems to go alright, but I still get detatching prints occasionally, or deforming mid-print. It’s kind of frustrating :(