Update: TL;DR: I cleaned the z-axis, replaced the nofep, installed the latest Chitubox (2.1) and cleaned up my profile to get it working

Hello, I hope someone will see this and be able to at least point me in the tight direction. As at this point I’m becoming desperate.

My Epax E10 4k is acting up, and I do not know why.

Part of the print is fine (see images) and then other parts are just stopped at a certain layer, with the rest stuck to the noFep.

I tried different prints, to make sure it wasn’t a layering problem, but alas… each single print suffered from the issue. The larger prints would ‘hang’ over non-printed layers…

I recalibrated my printer, changed the fep…

The one difference from before is the resin. I used to buy epax hard and tough, but my regular resin dealer doesn’t sell them anymore, heck it seems it is no longer available in europe. So I switched to the next best thing on the Epax compatibility list: eSun hard and tough.

Anybody have any clever idea?

  • tristan@aussie.zoneEnglish
    15·
    5 months ago

    It’s been a while since I used my resin printer, but I had a similar problem at one point and it came down to the support connection to the print… No matter how many supports I put, it didn’t change the outcome, but when I made the support thicker and made the connection point thicker, suddenly I had no more problems… It just meant a little extra post processing on some parts

    • bushvin@lemmy.worldOPEnglish
      2·
      5 months ago

      Thanks for taking the time to reply.

      I eventually ended up removing my slicer (Chitubox basic) and install the latest and greatest after cleaning up my profile. So literally starting anew.

      Aside from changing te resin, I didn’t modify any other settings to begin with, so my config was rather vanilla.

      After taking these steps (and cleaning the z-axis and replacing the nofep again) everything seems to be working fine now.

      Cleaning the axis and a new nofep didn’t seem to do anything, so I think it was just a crappy version of the slicer.